SKU/Artículo: AMZ-B07QQW7JZL
DIGITEN G1/2" Water Flow Sensor, Hall Effect Sensor Flow Meter Flowmeter Counter 1-30L/min - Arduino, Raspberry Pi, and Reverse Osmosis Filter Compatible
En stock
0.36 kg
Sí
Nuevo
Amazon
- Work for Arduino, Raspberry Pi, and Reverse Osmosis Filter. Small size, waterproof, easy to install, heat resistance, pressure resistance, cold resistance.
- Material: all materials are in line with ROHS testing standards, and can be used for potable water.
- Flow range:1-30L/min, working voltage range:DC 5-18 V, allow compression:Water pressure 1.75 Mpa below.
- Hall effect sensor. Wire connector type: SM-3P. Connect to G1/2 inch BSP male thread, if used for NPT, need thread seal tape. Output Waveform: Square Wave, output pulse signal.
- Wide application: It is mainly used in water heaters, coffee machines, water purifiers, drinking fountains, beverage machines, campus smart card equipment, etc.
IMPORTÁ FACIL
Comprando este producto podrás descontar el IVA con tu número de RUT
Conoce más detalles
Specifications:Frequency: F=7.5 * Q (L / Min) error: ± 2% , current can not exceed 10mA, 450 output pulses/liters. F=onstant * units of flow (L / min) * time (seconds)Flow range:1-30L/minMaximum current:10 mA(DC 5V) Working voltage range: DC 5-18 VLoad capacity: ≤10 mA(DC 5V) Operating Temp: ≤80℃.Operating humidity: 35%-90%RHAllow compression: Water pressure 1.75 Mpa belowInsulation resistance: >100M OHMStorage Temperature: -25-80℃Storage humidity: 25%-95%RHOutput Waveform: square wave,output pulse singal. Cable length:15cm.Refer to the wiring: Red wire: VCC(+) Black wire: GND(-) Yellow wire: Signal outputPackage include:Flowmeter x 1