BIT-C Pro Micro MCU with USB-C & DFU bootloader (ATmega32U4, 5V/16MHz) (Black)

0 5 4 66

66 calificaciones

Color:

Black

Disponibilidad:
En stock

Peso con empaque:
0.36 kg

Devolución:
Sí

Condición
Nuevo

Producto de:
Amazon

Sobre este producto

Pro-micro compatible microcontroller board featuring the Atmel ATmega32U4
Sturdy through-hole USB-C connector that is more rugged than a standard USB micro B
Ships with the Atmel DFU bootloader, which is smaller and less finicky than the default Caterina bootloader
The built in white LED shows power status by default, and can be set to 3 different brightnesses using GPIO controls
100% of Bit-C units are exhaustively tested before shipping, ensuring you're spending your time building, not debugging

U$S 43,98

55% OFF

U$S 19,99

U$S 43,98

55% OFF

U$S 19,99

Llega en 5 a 11 días hábiles

con envío

Tienes garantía de entrega

Medios de pago

Cantidad

Este producto viaja de USA

a tus manos en

Medios de pago

Conoce más detalles

A (much) better Pro Micro The Bit-C is a pro-micro compatible microcontroller board featuring the Atmel ATmega32U4, designed for DIY keyboard enthusiasts. It features a sturdy through-hole USB-C connector that is more rugged than a standard USB micro B. It's only 1mm thick, so it sits slim and low. The Bit-C ships with the Atmel DFU bootloader, which is smaller and less finicky than the default Caterina bootloader. 100% of Bit-C units are exhaustively tested before shipping, ensuring you're spending your time building, not debugging. Best of all, it comes in white! 100% Pro Micro compatible The Bit-C is a drop-in replacement for any Pro Micro MCU, including the Elite-C. With 1-1 GPIO pin parity, firmware builds don't need to be changed in order to swap in a Bit-C. The Bit-C is shipped with the lightweight Atmel DFU bootloader, making flashing with QMK a breeze. VBUS detection & backdrive protection are implemented for split keyboards, and a 500mA resettable fuse is included for protection. Tri-mode LED The built in white LED shows power status by default, and can be set to 3 different brightnesses using GPIO controls. Don't like the built-in LED? Turn it off. Use it to show layer or caps lock status. Bright, dim, and off modes allow for maximum flexibility. **NOTE: THE BIT-C SHIPS WITH THE ATMEL DFU BOOTLOADER BY DEFAULT. THIS BOOTLOADER IS NOT PROGRAMMABLE FROM THE ARDUINO IDE, AND WILL REQUIRE USING SPECIAL TOOLS, SUCH AS QMK TOOLBOX TO FLASH**